Separating condensate waste from LC waste

Separating condensate waste from LC waste allows the user to dispose of chemical waste separately.

Alliance iS systems are shipped with the condensate waste and LC waste routed to a single waste port on the front of the system.

1. Open the pump compartment door.
2. Remove the waste line tubing (see arrows) from the drain cup.

   

3. Lift the drain cup up.

   

4. Remove the screw (see arrow) on the left-hand side that secures the drain tray.

   

5. Pull the drain tray forward.

   

6. Remove the tubing from the drain tray.

   

7. Install the plug (see arrow) onto the drain tray barbed fitting.

   

8. Pull the drain tray tubing out of the back of the system and reroute it around the outside of the system to the front.
9. Push the drain tray back in.

   

10. Reinstall the drain cup.

    

11. Install the screw (see arrow) on the left-hand side that secures the drain tray.

    

12. Place the waste line tubing (see arrows) back into the drain cup.

    

13. If the condensate waste line is not long enough to reach the waste container:
    1. Remove the three screws and the cover on the back of the system that covers the condensate waste line.

       

       

       Condensate waste line cover

       

       Condensate waste line

       

       Screws

    2. Remove the condensate waste line (see arrow) from the SHC (sample heater cooler) drain cup.

       

    3. Make and install a new line long enough to connect to waste and connect it to the back of the system.
    4. Reinstall the three screws and the cover on the back of the system that covers the condensate waste line.
    5. Connect the new line to a dedicated condensate waste container. To avoid trapping air in the line, ensure that the tube is straight.